hexagon logo

Browse By Tags

  • ContinousTempSensor

    On a recent Hexagon service visit, the field engineer noticed in the setting editor that our “ContinousTempSensor” was turned off. He explained that it continuously samples the temperature throughout the routine, but wasn’t able to dive deeper. We are…
  • ERROR CE ,S% ,TR_CE ,0x1400304d Position out of the machine stoke limit

    Hello, I'm programming on a new CMM and having issues with my manual alignments. I have been programming in offline mode and whenever I try to run my programs on the machine after I pick up my manual alignment I get this error message: ERROR CE ,S% ,TR_CE…
  • code for checking an exception

    Need to calculate these from a set of 8 results [Spacing error not to exceed 0.005, spacing between adjacent slot 0.003, 1 place may be 0.005 max] I am using following code to calculate spacing error within 0.005, but I'm not sure how to find "…
  • PDF Report and report window Appending when I don't want it to

    I hope there is a simple solution for this. I tried searching the forum but found nothing related. Here is my scenario: The CMM operator runs the part and there are various errors. Some of them look like errors in programming. I take the PRG file…
  • Calibration "Out of Memory" Error 2017 & 2018

    I am currently running versions 2015, 2017 & now 2018 and I have a unique problem with only one machine running 2017 & 2018 but not 2015. This machine is running in Offline mode only. When I try to calibrate a new probe angle I get an 'Out of Memory…