I have come across another issue that im having with exact measure ( i have not tried this on "geometric tolerance command" yet). The problem i am having is the datum shift when applied thru simultaneous evaluation (s.e.) is making erroneous datum shifts…
Hello,
I am having trouble understanding how this TP callout can be out by so much. I attached a pic of what the report looks like and the code is shown below. Does anybody have any ideas? I have tried redoing the alignment but that did not…
I hope there is a simple solution for this. I tried searching the forum but found nothing related.
Here is my scenario:
The CMM operator runs the part and there are various errors. Some of them look like errors in programming. I take the PRG file…
