Dear sir,
I have a part having datum A as plane, Datum B&Datum C as circle but the Datum B is with an angle to Datum A, it is not perpendicular to Datum A so when i going to call the position of some circles wrt ABC then a message show as secondary…
Opinion needed:
Was wondering if it was possible for one of these holes (dat-c-) to give good t.p readings. Since the parts is symmetrical all 3 holes should be used with dat-a- for an alignment (a-c in feature control frame). So it would be possible…
I've been using the CMM for a about 4 years now in a job shop. We only use it when we *need* to (when we need to produce an inspection report for the customer). I'm the only CMM operator. Running 2012 MR1 CAD. I have several parts that I need to inspect…
