Is the node align tool broken in Hawk SP1?

I am trying to use the node align tool, to move a line of nodes on a HEX mesh to align on a straight curve. I cant however even select any form of node with the node align tool. Also is there an alternative approach by which I can split a 3D cell with just a line?

Parents

0 Darrel Sinclair over 6 years ago

The only way I can think of at the moment to do this would be to split the cell on two planes based on the curve. Attached PPT has a procedure for this. It's a little bit of a faff, but hopefully you don't have to do this for too many bolts...

Attached Files (1)

bolt_split.pptx
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Darrel Sinclair over 6 years ago

The only way I can think of at the moment to do this would be to split the cell on two planes based on the curve. Attached PPT has a procedure for this. It's a little bit of a faff, but hopefully you don't have to do this for too many bolts...

Attached Files (1)

bolt_split.pptx
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data