newbie

Major Deng 6 months ago

how can i move the part back to the position with the features?

should i move the origin close to the part?

I make the alignment and additional features

0 bfire85 6 months ago

Have you completed PC-DMIS training? It looks like there is an issue with your alignment. Best bet would be to post some code from Command Mode. You are currently in Summary Mode.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ArkansasBeeper 6 months ago

Yah, not sure what we are looking at here. Post your code and we can maybe help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Major Deng 6 months ago in reply to ArkansasBeeper

loaded some screenshots with coding
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ArkansasBeeper 6 months ago in reply to Major Deng

Is this a new program or an old one written by someone else?
Looks like that alignment is trying to roll the part into a different orientation?
Many of the vectors also seem off.

Have you taken any training for PC-DMIS?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Major Deng 6 months ago in reply to ArkansasBeeper

i did have a rough training process. now just try to practice in reality.

what i have done,

1. make alignments PLN1 (trumpet) PLN2 (square) CLY1 (end of the trumpet)

2, add additional features for measurements, e.g, holes etc.

3. then try other steps
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ArkansasBeeper 6 months ago in reply to Major Deng

Take a look at this post.
https://nexus.hexagon.com/community/public/pc-dmis/f/pc-dmis-for-cmms/138078/how-to-do-cad-to-part-alignment

Try to go to Hexagon training!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Major Deng 6 months ago in reply to ArkansasBeeper

thank you, will do!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel