how can i move the part back to the position with the features?
should i move the origin close to the part?
I make the alignment and additional features
Your Products have been synced, click here to refresh
how can i move the part back to the position with the features?
should i move the origin close to the part?
I make the alignment and additional features
Yah, not sure what we are looking at here. Post your code and we can maybe help.
loaded some screenshots with coding
Is this a new program or an old one written by someone else?
Looks like that alignment is trying to roll the part into a different orientation?
Many of the vectors also seem off.
Have you taken any training for PC-DMIS?
i did have a rough training process. now just try to practice in reality.
what i have done,
1. make alignments PLN1 (trumpet) PLN2 (square) CLY1 (end of the trumpet)
2, add additional features for measurements, e.g, holes etc.
3. then try other steps
Take a look at this post.
https://nexus.hexagon.com/community/public/pc-dmis/f/pc-dmis-for-cmms/138078/how-to-do-cad-to-part-alignment
Try to go to Hexagon training!
thank you, will do!
thank you, will do!
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |