Need help!!! Need Out Of Tol warning pop-up

I have been having an issue with our night shift operators that cant seem to read their reports before sending them along to the next op.

This is the 3rd time that parts have been sent back because a bad report was sent to a customer. Each group that is returned has to be 100% inspected, costing 20+ hours of inspection time. This has got to stop. I was wondering if there was a way to make a dialog box pop up if a dimension registers out of tolerance. Anything would help!

I greatly appreciate any help.

Parents

AndersI over 9 years ago

In the Code section there's my "Count OUTTOL" script, which includes FCF:s - http://www.pcdmisforum.com/showthread.php?30251-Counting-OUTTOL-in-a-program

Just insert the red lines at the indicated end of the script:

  If Not OutTolValue is Nothing Then
    Part.SetVariableValue OutTolVar, OutTolValue
  End If
[COLOR="#FF0000"]
  if (OutTolValue > 0) then
    MsgBox "Some values are out of tolerance! Check the report"
  end if
[/COLOR]
Else
   MsgBox "Variabeln " + OutTolVar + " saknas i PCDMIS-programmet!"

Reply

AndersI over 9 years ago

  If Not OutTolValue is Nothing Then
    Part.SetVariableValue OutTolVar, OutTolValue
  End If
[COLOR="#FF0000"]
  if (OutTolValue > 0) then
    MsgBox "Some values are out of tolerance! Check the report"
  end if
[/COLOR]
Else
   MsgBox "Variabeln " + OutTolVar + " saknas i PCDMIS-programmet!"

Children

No Data