TCP/IP failed ???????

I've tried looking to see if anyone has had this problem with no luck. When I fire up PCDMIS I get a TCP/IP communication failed switch to RS/232 . I'm running PCDMIS 2015.0 and a brown and sharp global cmm . Thanks in advance .

dph51 over 8 years ago
Try this.....

[thread] TCP/IP Communication Failed Switch to RS-232?[/thread]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
TODDTODDTHECMMGOD over 8 years ago

When we had that issue, it was related to our antivirus software.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Mike_B over 8 years ago

Or.. http://www.pcdmisforum.com/showthread.php?22503-tcp-ip-port-setting
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
John Kugler over 8 years ago

When we had that issue, it was related to our antivirus software.

Can I ask what you did to rectify this? We have the same TCP/IP issue. Before that, our antivirus software cut off the cable to the network. IT un-installed the antivirus, but now we have the TCP/IP error.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Wes Cisco over 8 years ago

from my notes:

edit>machine interface setup
leitz protocol setup tab
check box "use TCP/IP link to drive the machine" needs to be checked

then go to windoze start menu>settings>network connections

probably have two cards, one is internet, other is controller

TCP/IP address: 80.128.0.2
subnet mask : 255.0.0.0

default gateway : left blank

hth
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
cmccullough over 8 years ago

What type of controller is it??
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
BillG3 over 7 years ago in reply to Wes Cisco

Sorry for replying to an old post but this from Wes helped me after a PC and PCDMIS upgrade. In my network settings it was set to automatically find the IP address. Then i switched it to manual and input the TCP/IP address and subnet mask and everything works like a charm now. Thank You!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel