Thank you for your feedback. That was the whole program. I took 3 samples hits on manual mode, then went for DCC, realized there was a big offset on Y direction from CYL-C, so I added a sample hit on datum B which was over 8 mm. I found one issue, 6 hits might not be enough for a cylinder on manual mode.
I did read 101 again. Manual cylinder does not work, all hits should be in layers, but we can not control hits, no matter 3 or 4 hits in a layer at all.
I did read 101 again. Manual cylinder does not work, all hits should be in layers, but we can not control hits, no matter 3 or 4 hits in a layer at all.