Thank you for your feedback. That was the whole program. I took 3 samples hits on manual mode, then went for DCC, realized there was a big offset on Y direction from CYL-C, so I added a sample hit on datum B which was over 8 mm. I found one issue, 6 hits might not be enough for a cylinder on manual mode.
best bet for manually learned cylinder is to use 3 levels with 4-3-5 hits per level, there is no way Pcdmis can muck up the vector that way as only 1 cylinder will ever fit those hits. As for 'control', no need for 'precise' control for the levels, 'just close' is close enough.
best bet for manually learned cylinder is to use 3 levels with 4-3-5 hits per level, there is no way Pcdmis can muck up the vector that way as only 1 cylinder will ever fit those hits. As for 'control', no need for 'precise' control for the levels, 'just close' is close enough.