Good afternoon all,
I am trying to set up a quick program to measure a true position call out for a part we are running at the shop. it is a small bushing and the TP call out is the O.D. cylinder to the I.D. cylinder (datum A) and a perpendicular…
I came across a print requirement too inspect TP of an open slot on a circular disk as shown in image attached.
what would be the correct way to inspect this?
Hello everyone
I need to inspect TP of a tapered through hole on a cylindrical surface at a distance of R. 10.4 from center of part as shown in image,
any thoughts on how this can be inspected..
Attached Files
Hello everyone!
last week i came across an issue in which first hole was mismarked during production.
The part was similar to attached image with two set of holes 1st set has 30 holes and 2nd has 59, in which 1st hole of both set are inline with each…
is there any code we can use to calculate this from set true position values?
for a circular disk with 60 slots at od.
SPACING ERROR NOT TO EXCEED 0.005 TOTAL.
SPACING ERROR BETWEEN ADJACENT SLOT 0.003 MAX AT 60 PLACES.
1 PLACE MAY BE 0.005 MAX…
Hi there,
I need help. I've received a ASME drawing in inches from a client (i usually work on ISO and with mm) and they've demanded that I measure a position with the MMC condition in the hole and for each datums (B and C).
The thing is that i…
Where I work I very frequently have position dimensions called out in sets. When the DRF is not fully constrained, or when there are MMB modifiers on datums, its critical to call the holes out as sets so any Datum Shift is the same for all the holes in…
Good Morning! I have this part (shown below) that calls out a slot as the tertiary datum and I am having trouble trying to get the true position to show the MMC to .0002 for the callout for -D-. I am measuring it by taking 1 hit on each side of the slot…
Good Morning! I am still very new to PC-DMIS and I am having trouble with the Xact measurement of a true position callout for a feature. The callout for the hole should read TP/ Ø.005 @ MMC/ A @ MMC but when I try to dimension it, it does not allow me…
dear all,
I am new guy for PCDMIS, currently I am using PC-DMIS rev 4.3 and 2012.
recently, I found a problem with a program for my product. it is about a true position of a circle, please refer to attached photo for details.
a circle which is…
I Have trouble when showing True Position on FCF,
There is some information i want to hide or delete, that is location on Datum which shown in Position tab, that information come when i add secondary and tertiery datum with MMC or LMC on True Position…
