hexagon logo

Anyone using Dataview?

Apparantly not many folks use it bit is anyone using it?
Some of my customers are limited by their inability to visualize reported data
in excel format so I'm thinking I should check out Dataview since we already paid for it.
Anyone?

Thanks
MJB
Parents
  • You dont haft to use macro. Everything comes from the data base the macro has nothing to do with the part program besides the data base used within it and dimesions reported which where else would you get the data some pull it out of there a... but mine comes from the part measured. Data view is intended to be a constant charting system for eng. to follow inspections and adjust tooling. It works great if setup correctly. JC

    I get my "pretty-picture" reports out of Excel:



    Changing the value in a single cell of the form will change it to display one of the following:
    Road Map
    Single Part check results
    Study check averages
    Study range
    Tolerance for each point
    OUT of tolerance features will have the border turn to red

    Spc points can also be done and they will display Ppk values as well as check results.
Reply
  • You dont haft to use macro. Everything comes from the data base the macro has nothing to do with the part program besides the data base used within it and dimesions reported which where else would you get the data some pull it out of there a... but mine comes from the part measured. Data view is intended to be a constant charting system for eng. to follow inspections and adjust tooling. It works great if setup correctly. JC

    I get my "pretty-picture" reports out of Excel:



    Changing the value in a single cell of the form will change it to display one of the following:
    Road Map
    Single Part check results
    Study check averages
    Study range
    Tolerance for each point
    OUT of tolerance features will have the border turn to red

    Spc points can also be done and they will display Ppk values as well as check results.
Children
No Data