Just converted over from Datapage to Datapage+ to run with my 2012MR1 upgrade. Slowly learning how this work but there is one question, why does it take so long at the end of my program to transfer the data over to the database. Both are located locally. See the attachement. It takes up to 2 minutes.
If you using an external command to send the data to datapage+ make sure the No wait button is checked.
Then go to the start menu go down to datapage+ in there is a folder called tools within that folder start the data importer third section from the bottom adjust the auto check.
If you using an external command to send the data to datapage+ make sure the No wait button is checked.
Then go to the start menu go down to datapage+ in there is a folder called tools within that folder start the data importer third section from the bottom adjust the auto check.
