I was wondering if anybody has had an issue with Datapage + 2012 not seeing the Portlock sometimes? Some days when i am running a part in Dmis and try to open Datapage + i get a pop up that says "You do not have a portlock. Datapage + cannot continue". If i wait until the inspection program is finished running and do a computer restart, Datapage + opens. It doesn't do this all the time. Does anybody know if there is a setting i need to check/change to correct this.
Thank you in advance.
do you have two portlocks?
if so then update the safenet drivers to handle both portlocks at the same time and make sure pcdmis can handle it.
if you only have one portlock then get hex to replace it as its on the way out.
do you have two portlocks?
if so then update the safenet drivers to handle both portlocks at the same time and make sure pcdmis can handle it.
if you only have one portlock then get hex to replace it as its on the way out.
