Does anyone know why PCDMIS would report a value as Inboard, but when I create my report in datapage it says Outboard? I'll post a pic when I get a minute, one of my engineers just noticed this. Very frustrating!!!
The measured value of Y is "more positive then your nominal". The T value shows less material then the models nominal or minus from where the point was to be taken. Both the Y value and the T value state that the surface did not have enough material on it. I think the report is showing the T value.
The measured value of Y is "more positive then your nominal". The T value shows less material then the models nominal or minus from where the point was to be taken. Both the Y value and the T value state that the surface did not have enough material on it. I think the report is showing the T value.
I think that is what you are asking?