Does anyone know why PCDMIS would report a value as Inboard, but when I create my report in datapage it says Outboard? I'll post a pic when I get a minute, one of my engineers just noticed this. Very frustrating!!!
I think you missed what I was saying... The Y nominal is a negative value. The measured value is a lesser negative " or in a positive direction. The T value works off of vectors of the surface you measure. The + vector for the T is always away from the part.
I think you missed what I was saying... The Y nominal is a negative value. The measured value is a lesser negative " or in a positive direction. The T value works off of vectors of the surface you measure. The + vector for the T is always away from the part.
