Hello, I'm programming on a new CMM and having issues with my manual alignments. I have been programming in offline mode and whenever I try to run my programs on the machine after I pick up my manual alignment I get this error message: ERROR CE ,S% ,TR_CE…
Good afternoon all,
I am trying to set up a quick program to measure a true position call out for a part we are running at the shop. it is a small bushing and the TP call out is the O.D. cylinder to the I.D. cylinder (datum A) and a perpendicular…
Hello All,
My company has recently run a program on two CMMs.
The first time the program was run, each loadprobe line would prompt the operator to load that probe before moving forward.
When the program was run on a different CMM, the program…
The clear planes in my program do not want to co-operate today. I'm using a read point for the manual alignment, as far as I can see I did not forget to translate my Z. DCC_ORG Is a circle that takes 3 sample hits on the Z=0 surface I want. The clearplane…
Edit: reducing the hits to 3 INCREASED the accuracy of my measurements. Special thanks to UKCMM!
So I was measuring a cylinder and I got some pretty crazy results (See the diameter). Trying to figure out why this happened beyond some good ol…
Hi All
I use PC-DMIS CAD++ 2019 R1 on B&S 5.7.5, its absolute speed is 700 (this is what I see when I open F5 ). Most of our programs run with speed 200-300mm/s. I changed it to 500 in program edit window but didn't see any difference.
I searched…
I am unaware of any option in the settings to turn off move points. I have tried Cntrl+M typing in move/ and hitting the move point button on the jog box. I have also been trying to make a clearance plane and I cannot add move/clearplane either. Does…
Hello,
I'm pretty new to PC-DMIS and CMM programming in general. I've been working with it for a few months now. My problem is this. I keep getting an out of stroke error when switching to DCC alignment and I'm not sure what I'm doing wrong. The machine…
