Hello:)
What would be the best way to measure the tolerance distance on this part. I did a crossection on the CAD model but this gives me deviation on both the distance and the diameter, i only want the deviation on the distance. What would be the…
Hello all
I'm trying to calculate a cone from a set of points with an angle & base fixed, I'm using the command SETITR to fix these values, but I see in the mask that is only possible to fix the Angle (A-Value)
Do you know a way to constraint both…
Hi,
End of measurements i notice something in the report that actual values have gone back to nominal values.
This has happened on three different things.
1) Constructed circle from a measured cone( here i use height, value, origin, workplane…
is there any way to skip hole on a cone that has flats on it? i cant get it to rotate around even when i modify the start and end angles. Also, the path lines dont match the measurement strategy. not sure what exactly is going on, maybe i am doing something…
We run both Zeiss Calypso and PC-DMIS here and when we measure a cylinder head for all the valve parameters(deck, seat, valve guide, etc) we get answers that we agree with on Calypso but not on PC-DMIS. We are trying to scan both with circles and lines…
We have a family of parts and the only difference between them is the over all length. Each has a 4° taper that is .5" deep and I have been having random best fit calculation errors when they are measured. Can run any of these parts and have not problems…
Trying to use auto-cone to generate one cone that is on top of flat surface. Result is showing two cones. Have done same part before but don't remember this happening. Is there a setting that could cause this. Am using PC-DMIS 4.3 on Brown & Sharp One…
