Faro Arm pc-dmis Edit Probe Data

Are you certain that your your 12" block isn't 12.5"? Check it with calipers or even a tape measure. It just seems to me that the numbers are too even.

Bill

Thats's what i thought, I also checked it with calipers it is 12.0000" its also a certified block but i think it has something to do with the Edit Probe Data Feature or something else you might think it is?

If probe comp. isn't turned on and your probe is exactly .25" (6.35mm) and you took points on both ends, you would see +/- 12.5". Is your probe comp turned on? Oh and I haven't touched a Faro arm in at least 10 years so anything I tell you may be totally useless.

Bill

were do I turn on or off my my probe comp?

I appriaciate all the help I can get

parameter settings found it
thanks for the help will reply monday to see if it works time to go home!!

Aiden,

It could also be your angle of approach for measuring those points. Measure the points on the ends as square to the surface as you can get. make sure your probe is coming in at at least more than a 45 degree angle to the surface. If you are obstructed somehhow from doing this, take a 3 point plane instead of a single vector point. Can you post some code from your program? If the top of your block is the XY plane (normal to the Z axis) and the front of your block runs in line with the X axis, then the points your taking on the left and right ends of the block should have IJK values of -1,0,0 and 1,0,0 respectively. Otherwise the software is compensating to the bottom of probe, and you would have the radius of the probe added to each end of the block. 12.000" + 2X.125" which would be 12.25". Since you are getting 12.5", I almost wonder if you don't have the probe identified wrong. You're certain it's a .25"(6.35mm) probe?
That said, you really shouldn't be calibrating ANYTHING with a PCMM. Vernier Calipers are even better than using a Faro or Romer Arm for the task, IMHO.