if i position my probe just above a bore, some where near central, then insert a read point, then origin to that read point in xyz. why cant i then use an auto circle to measure the bore by typing in the circle features as x=0 y=0 z=-3, i think the vectors are correct, it all looks good on the graphics but the probe just moves to the right at the same height, not at z=-3
I believe we already covered this, in the same exact thread, posted in the appropriate forum, a few days ago. Although, the OP never did come back and say whether the issue was resolved.
I believe we already covered this, in the same exact thread, posted in the appropriate forum, a few days ago. Although, the OP never did come back and say whether the issue was resolved.
