Good Afternoon
1st time I'm trying to use equate alignment for a long part - I used to measure part in 2 separated stages so I have 2 separated independent programs. I combined them in one program remembering to change IDs in stage 2 to avoid duplicates…
Hello All,
My company has recently run a program on two CMMs.
The first time the program was run, each loadprobe line would prompt the operator to load that probe before moving forward.
When the program was run on a different CMM, the program…
I am unaware of any option in the settings to turn off move points. I have tried Cntrl+M typing in move/ and hitting the move point button on the jog box. I have also been trying to make a clearance plane and I cannot add move/clearplane either. Does…
Hello everyone, I’m using body axis scan to create 3D lines then intersect the lines. One line horizontal and the other roughly vertical.
My concern is the lines are not where I expect they would be.
For example I set a body axis scan for Z-6.000…
