Hello everyone!
last week i came across an issue in which first hole was mismarked during production.
The part was similar to attached image with two set of holes 1st set has 30 holes and 2nd has 59, in which 1st hole of both set are inline with each…
Need help!! Not sure why PC-DMIS keeps giving me bad results. I have created different alignments, different hits, different workplanes and views but PC-DMIS still gives me wrong numbers. Any suggestions on what is going on?
On the blueprint I have…
Hi,
i am trying to inspect TP of a point considering only PA (angular variation),
while generating output I'm getting same value wile when considering both PA & PA.
can someone please guide me what's going wrong and how i can generate TP with PA…
Dear sir,
I have a part having datum A as plane, Datum B&Datum C as circle but the Datum B is with an angle to Datum A, it is not perpendicular to Datum A so when i going to call the position of some circles wrt ABC then a message show as secondary…
Can someone please help me figure out the best way to set up an alignment with only 2 datums? The print I am working off only has a datum A plane and a datum b diameter and is wanting some gd&t position information just using A & B instead of the A, B…
Opinion needed:
Was wondering if it was possible for one of these holes (dat-c-) to give good t.p readings. Since the parts is symmetrical all 3 holes should be used with dat-a- for an alignment (a-c in feature control frame). So it would be possible…
I've been using the CMM for a about 4 years now in a job shop. We only use it when we *need* to (when we need to produce an inspection report for the customer). I'm the only CMM operator. Running 2012 MR1 CAD. I have several parts that I need to inspect…
