I'm trying to use a PolyUMod model (TNV) into Marc Mentat 2024, I followed the steps showed in the PolymerFem Tutorial ( How to Use a PolyUMod Material Model in MSC Mentat ) but Marc shows me the Error 13.
Here's my TNV model file text:
ModeloTNV1…
Hi Community,
I hope you're doing well!
I'm working on a project in Marc Mentat and need a little help. I'm trying to figure out how to extract stress or strain values at the centroid of an element. I do have the element ID and the stress/strain data…
The only difference between the two models is that for one, I specify a failure model thanks to "MATF" and ask for the strength ratios with "PARAM,SRCOMPS,YES".
Doing that, I obtain a 40% higher stress.
I have made sure that SR>>1 so that…
I am using GAP elements in a nonlinear static solution to analyze the deflection of a clamp as it presses down on ceramic block. There are discrete faces that contact the ceramic and I defined gap elements between them and the ceramic. As I increment…
Currently it takes about 1min to complete one analysis. however, i have over 40k bdf files. Is there a way that can significantly reduce the time? The Nastran Command options dont seem to help much.
my bdf file is 16.5mb large. i cant upload…
I have an issue where applying either a total load or force on a model with frictional contacts causes large displacements at the first time step (2% of load) and it doesn't converge. It does work with an enforced displacement however.
I am attempting to get correct displacements for a simple beam with an enforced rotation applied to one end -- please see the attached .dat file. "Correct displacements" are ones where the free end of the beam moves in an arc, not in a line. In my case…
Hello,
Is it possible to supply scale factors corresponding to the scaled shapes of each SOL 105 mode so as to introduce geometric imperfections to the FEM?
I know of the long ended way of doing this using MSC.Patran (using fields…
Hi All
I am running a nonlinear FE_PART model and would like to obtain the stress and strain values along the beam. Essentially I am just looking for the point of maximum stress. I am not sure if there is a post-process step I am missing,…
Hello,
I make nonlinear analysis with touched contact. My model made by 3d shell elements on Marc Mentat. I have force on shell body which bends and have contact with other shell body. My contact is between two deformable shell with two shell…
I have been successful in extracting pre-loaded nonlinear stiffness matrices using EXTSEOUT in SOL 103 restarting from a SOL106, such as suggested in the topic:
forums.mscsoftware.com/.../showflat.php
Now, I need to do the same…
When running SOL 128 - nonlinear harmonic frequency solution - I get a FATAL message that there are no nonlinear degrees of freedom defined. How do I define these?
