Trying to get an autosphere reading on this surface here, but the probe is hitting the surface on the right of it instead of the actual "sphere." The targets I'm trying to hit are in red and what's actually being hit by the machine is in blue. Its basically…
Hello.
First of all, excuse me if i'm not very understandable. I'll try to be as clear as possible.
I'm French and i teach CMM with PC DMIS. We have a Tigo SF. We're having trouble with the probe changer : after calibration, we use the standard protocole…
I have problems with creating simple line
the firs line is mesured on x-3 instead of -1 and its cannot be fixed - its allways difference in 2mm in measurement
when i tried to create second line then i do not know what happen pc-dmis says what there…
Hello, everyone!
Nowadays I am working with HEXAGON Dea and during last 3 weeks I started to notice, that sometimes, after switching on a new program, CMM goes into emergency mode. After pressing Motor On it does't give the opportunity to work, due…
Does anybody know why I cannot select different tabs in the auto feature window?
-I have re installed dmis
-and I am in DCC
-it doesnt matter which auto feature i am using
Good morning. I'm working in the offline seat today and I'm having some issues with auto cylinder. When I attempt to update anything in the contact properties tab it does not update on the CAD. I did a quick search, but couldn't find a solution right…
I have a part that basically looks like a Gauge Pin with a hole drilled thru it (90 perp to the longitudinal axis of the cyl).
I am having a very difficult time trying to get this thing aligned using CAD. I have tried 3 points on one of the flat ends…
I wrote a program based off of a CAD model on our offline seat that uses 2010MR2. I saved it as a "2010" version, since that's the program that I'll be using it in when I'm out on the CMM. Everything opens up fine, but any auto-feature that I had created…
