hexagon logo
Register Sign in

Browse By Tags

  • verify keyway position

    Hello there! I'm new in this forum and I hope I pick the right group for my question. I have to check this tolerance: I tried a lot of times and I couldn't find a reliable code to check on this tolerance. Any idea about the strategy? Thanks…

  • Bonus calculation

    I am facing difficulties figuring out how pc-dmis is calculating bonus tolerance. in the two attachments when circle was a measured feature bonus tolerance was 0.0022, for the same feature when it's used as datum tolerance changed to 0.0062. …

  • Updating point tolerances

    I have a run chart layout that's already been run and the customer wants to change the tolerances. Is there any way I can do this in Datapage? Or do I have to go through pc dmis and change them point by point? Thanks!

  • understanding unequal tolerance reporting

    I have a profile with only a negative tolerance. How is my measured value positive, but the part is checking outtol=0. is the meas on the report an absolute value? I am exporting everything to measurlink and it is having trouble with the negative tolerance…

  • Location of edges with hole pattern as datum

    I have manufactured two parts that are going to be assembled. The top part with four holes is going to be assembled to the bottom part consisting of four pins and an elevated L-shape (See Figure), such that when the top part is placed on top of the bottom…

  • Locking in Basic Dimensions to center of Circle/ Radius

    I program/ operate a global performance 7.10.7 CMM and I am running 2014 version of PC DMIS. I am attempting to measure some radii that are located by basic dimensions. What is the best way to do this? I tried to input theoretical values of X, Y,…

  • Need help!!! Need Out Of Tol warning pop-up

    I have been having an issue with our night shift operators that cant seem to read their reports before sending them along to the next op. This is the 3rd time that parts have been sent back because a bad report was sent to a customer. Each group that…

  • Reporting Question

    I have a quick question about the reporting format. I have a part that I am checking and one of the dimensions has a profile tolerance. I would to set the report up so that parts measuring negative for that specific dimension will display a warning. I…

  • mystery tolerance..

    See attached picture. Where does the tolerance (circled in red) come from? I know it has something to do with MMB on Datum B, but can't quite figure out how it ties in... Thanks Sam

  • Basic Dimensions and General Feature Control Frame

    I have a quick question. I have been told by corporate engineering to take the General Notes, Surface Profile Feature Contrl Frame on the drawing and apply it's tolerance to the basic dimensions. Is this the proper way to utilize basic dimensions…

  • color scale for deviation tolerance

    Hello folks, First and foremost, happy 4th of July to all of you. I'm having issues in report window. Once I scan my part with the laser CMS, I want to see the value of my variation. At the bottom of the page in report windown I have a scale color…

  • Angle Dimension Probs....

    Hi all, I have a 2 fold question/problem and I believe they are connected. #1 When I create an angle dim. in the creation box I will type in the tolerances and the nominal. Say my nominal is 5*32'55", well.. when I report the angle in the report…

  • Feature With HUGE Tolerance

    I am being asked to confirm the orientation of a round clip, similar to a hose clamp. The dimension is an angle, and the tolerance is ±45°. Since the clip can be anywhere in this 90° range, what is the best way for the CMM to 'find' it? (without taking…
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement