I have 2010MR3 and 2011 on the PC. I can calibrate the CMM-V with no error on 2010MR3. I built the same probe on 2011, and the calibration stop with this kind of message : "Focus detection error in one position".
I have only two choices : retry or cancel. If I retry, it's the same, if I cancel, the probe is not calibrated !!!!!
What can I do ?
(I prefer 2011 for some fixed bugs on tool changer...)
Not at all... I search the differences between the two versions. I found out that the 2 CMM-Ve are still presents in the probe.dat (and I don't understand why).
The major problem that I found this afternoon is in the setting editors : the parameter of camera is not read from 2010MR3 to 2011. It's a parameter that describe the type of wire and the type of video that you have (BNC + PAL in my config). I setted this parameter in 2010 MR3 to "3", but It stayed at "1" when I installed 2011. I will know it next time !!!!!
So far I've been told that settings not coming over is most often a permissions issue, and the best tactic is to always run the installation and PC-DMIS as administrator (right click/run as administrator).
So far I've been told that settings not coming over is most often a permissions issue, and the best tactic is to always run the installation and PC-DMIS as administrator (right click/run as administrator).
2012 MR1 : one more time, I have some problems to calibrate CMM-Ve (optical calibration) : I works with 2010 MR3, but when I want to calibrate with 2011 or 2012 MR1, I have an error message TR MIN M2, parameter larger than permetted, and an axis W appears in probe result window, even if I don't have rotary table !!!!!
Another problem is that angles calibration doesn't give good results on a sphere between A0B0 and A90B90 (about 1 mm error !!!!!). It was Ok in december, and the problem appears on 2 CMM in january...
Any help would be appreciated ! I feel alone !
have you made sure all the settings are correct in the settings editor for the cmm-v. When installing newer versions of pc-dmis I have had those setting change on me. I always have to double check the CMM-V/FOCUS PULSE = 32 and the MSI / FRAMEGRABBER TYPE = 301. Not sure what your settings should be. Also make sure that the settings are right in the machine interface setup.
