hexagon logo
Register Sign in

  • equate alignment step by step

    Good Afternoon 1st time I'm trying to use equate alignment for a long part - I used to measure part in 2 separated stages so I have 2 separated independent programs. I combined them in one program remembering to change IDs in stage 2 to avoid duplicates…

  • Measured Probe Diameter Error Exceeds limits

    I am newer to programing and mostly just use the vision part of my machine. But seem to be having some issues with the Tactile side of my machine. Half way though probe calibration I get this "Measured probe diameter error exceeds limits." It then…

  • Autocalibration Calibration Sphere

    Hello All, I'm not sure if this is a common thing but i have an auto calibration program I set up to calibrate all our angles at once with. We have multiple calibration spheres that we use, for example when one is out to be certified by a 3rd party…

  • Loadprobe Command does not Prompt Operator

    Hello All, My company has recently run a program on two CMMs. The first time the program was run, each loadprobe line would prompt the operator to load that probe before moving forward. When the program was run on a different CMM, the program…

  • Not able to add Move Points into code or by shortcut keys

    I am unaware of any option in the settings to turn off move points. I have tried Cntrl+M typing in move/ and hitting the move point button on the jog box. I have also been trying to make a clearance plane and I cannot add move/clearplane either. Does…

  • Probe calibration - Wrong parameter

    Hi all, i've got an issue with probe calibration. If i want to start tip cal, pc dmis will write that the parameter is wrong. I tried to reset tips, create new tips, call backup, copy new PROBE.dat. The machine can normally measure, but i cannot start…

  • Optiv Hardware & 64-bit

    Hello! Running PC-DMIS 2013 MR1 SP5 on an Optiv Performance z443 ---------------------------------------------------------------------------------------- The short and sweet of it is: I want 64-bit Windows. The story is, I've got this Optiv…

  • Vision Crashes When Measuring Circles

    Running PC-DMIS 2013 MR1 SP5 on Windows 7 PC connected to an Optiv Performance z443 ------------------------------------------------------------------------ Hello! I have several part programs that run though to completion using touch probes I…

  • Body axis scan question

    Hello everyone, I’m using body axis scan to create 3D lines then intersect the lines. One line horizontal and the other roughly vertical. My concern is the lines are not where I expect they would be. For example I set a body axis scan for Z-6.000…

  • Retract distance problem

    I just had Cad++ installed and I am having problems when I probe a hole and my probe retracts past the center of the hole and hits the back of the hole which inturn retracts and hits the front of the hole and goes into a loop of back and forth hits. I…
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement