The analysis of positional tolerances is based on the evaluation of pairs of values (x-coordinate and y-coordinate). Positional tolerances are typically applied to bore holes whose position is tolerated in x-direction, y-direction and z-direction.
| Positional Tolerances This document describes the special settings that only apply to this graphic and the option of the Best-Fit-Move. |
English:PDF | German:PDF |
| Calculation of Positional Tolerances The purpose of this document is to clarify what a position deviation is. It describes the mathematical point of positional tolerances and how to create them. |
English:PDF | German:PDF |
|
General configuration
Options for general graphics configuration are stored in the "Graphical settings" tab. Link to Q-DAS Graphics - General Configuration |
||
|
Working with the graphics
The "Part / characteristic" tab provides options and functions for working with graphics. These include various data selection options for display and evaluation, as well as various configuration options for the displaying multiple characteristics. Link to Working with the Q-DAS Graphics |
